SIPLUS SIMOCODE PRO VBASIC UNIT 2-25 ... +60 DEGREES CWITH CONFORMAL COATINGBASED ON 3UF7010-1AU00-0.PROFIBUS DP INTERFACE12 MBIT/S RS485; 4I/3O FREELYPARAMETERIZABLE;US: AC/DC 110-240V;INPUT F.THERMISTORMOTOR PROTECTION;RELAY OUTPUTSMONOSTABLE; EXPANDABLEBY EXPANSION MODULES

Technická data

Název:

SIPLUS SIMOCODE PRO V (Basic unit 2)

Popis:

SIPLUS SIMOCODE PRO V BASIC UNIT 2 -25 ... +60 DEGREES C WITH CONFORMAL COATING BASED ON 3UF7010-1AU00-0 . PROFIBUS DP INTERFACE 12 MBIT/S RS485; 4I/3O FREELY PARAMETERIZABLE; US: AC/DC 110-240V; INPUT F.THERMISTOR MOTOR PROTECTION; RELAY OUTPUTS MONOSTABLE; EXPANDABLE BY EXPANSION MODULES

Technické informace:

Product designation		SIPLUS SIMOCODE pro V motor management system
Design of the product		basic unit 2
General technical data
Product function
● data acquisition function		Yes
● Diagnostics function		Yes
● Password protection		Yes
● Test function		Yes
● maintenance function		Yes
Product component
● Digital input		Yes
● input for analog temperature sensors		No
● input for ground fault detection		No
● Relay output		Yes
Product extension
● Temperature monitoring module		Yes
● Current measuring module		Yes
● Current/voltage measuring module		Yes
● failsafe digital I/O module		Yes
● Ground fault monitoring module		Yes
● decoupling module		Yes
● digital I/O module		Yes
● Control unit with display		Yes
● Control unit		Yes
● analog I/O module		Yes
Power loss [W] total typical		7 W
Insulation voltage
● rated value		300 V
● with degree of pollution 3 rated value		300 V
Surge voltage resistance rated value		4 000 V
Protection class IP		IP20
Shock resistance
● acc. to IEC 60068-2-27		15g / 11 ms
Vibration resistance		1-6 Hz / 15 mm; 6-500 Hz / 2 g
Switching behavior		monostable
Switching capacity current of the NO contacts of the relay outputs at AC-15
● at 24 V		6 A
● at 120 V		6 A
● at 230 V		3 A
Switching capacity current of the NO contacts of the relay outputs at DC-13
● at 24 V		2 A
● at 60 V		0.55 A
Mechanical service life (switching cycles)
● typical		10 000 000
Electrical endurance (switching cycles)
● typical		100 000
Equipment marking
● acc. to DIN EN 61346-2		F
● acc. to DIN EN 81346-2		F
Continuous current of the NO contacts of the relay outputs
● at 50 °C		6 A
● at 60 °C		5 A
Electromagnetic compatibility
EMC emitted interference
● acc. to IEC 60947-1		class A
EMI immunity acc. to IEC 60947-1		corresponds to degree of severity 3
Conducted interference
● due to burst acc. to IEC 61000-4-4		2 kV (power ports) / 1 kV (signal ports)
● due to conductor-earth surge acc. to IEC 61000-4-5		2 kV
● due to conductor-conductor surge acc. to IEC 61000-4-5		1 kV
● due to high-frequency radiation acc. to IEC 61000-4-6		10 V
Field-bound parasitic coupling acc. to IEC 61000-4-3		10 V/m
Electrostatic discharge acc. to IEC 61000-4-2		6 kV contact discharge / 8 kV air discharge
Conducted HF-interference emissions acc. to CISPR11		corresponds to degree of severity A
Field-bound HF-interference emission acc. to CISPR11		corresponds to degree of severity A
Inputs/ Outputs
Product function
● Parameterizable inputs		Yes
● Parameterizable outputs		Yes
Number of inputs		4
● for thermistor connection		1
Number of digital inputs
● with a common reference potential		4
Digital input version
● Type 1 acc. to IEC 61131		Yes
Input voltage at digital input at DC rated value		24 V
Number of outputs		3
Number of outputs as contact-affected switching element		3
Number of semiconductor outputs		0
Wire length for digital signals maximum		300 m
Wire length for thermistor connection
● with conductor cross-section = 0.5 mm² maximum		50 m
● with conductor cross-section = 1.5 mm² maximum		150 m
● with conductor cross-section = 2.5 mm² maximum		250 m
Interfaces
Number of interfaces
● acc. to PROFIBUS		1
Protective and monitoring functions
Product function
● Phase unbalance		Yes
● blocking current evaluation		Yes
● power factor monitoring		Yes
● Ground fault detection		Yes
● Phase failure detection		Yes
● phase sequence recognition		Yes
● voltage detection		Yes
● Monitoring of number of start operations		Yes
● Overvoltage detection		Yes
● Overcurrent detection 1 phase		Yes
● undervoltage detection		Yes
● undercurrent detection 1 phase		Yes
● active power measurement		Yes
● active power monitoring		Yes
Motor protection functions
Product function
● Current detection		Yes
● Overload protection		Yes
● Evaluation of thermistor motor protection		Yes
Response value of thermoresistor		3 800 ... 3 400 Ω
Release value of thermoresistor		1 500 ... 1 650 Ω
Explosion device group and category acc. to ATEX product directive 94/9/EC		Ex II (2) GD / Ex I (M2)
Motor control functions
Product function
● parameterizable overload relay		Yes
● circuit breaker control		Yes
● direct start		Yes
● reverse starting		Yes
● star-delta circuit		Yes
● star-delta reversing circuit		Yes
● Dahlander circuit		Yes
● Dahlander reversing circuit		Yes
● pole-changing switch circuit		Yes
● pole-changing switch reversing circuit		Yes
● Slide control		Yes
● valve control		Yes
Communication/ Protocol
Product function Bus communication		Yes
Protocol is supported
● PROFIBUS DP protocol		Yes
● PROFINET IO protocol		No
● PROFIsafe protocol		Yes
● Modbus RTU		No
● LLDP		No
● Address Resolution Protocol (ARP)		No
● SNMP		No
● HTTPS		No
● OPC UA Server		No
● NTP		No
● Media Redundancy Protocol (MRP)		No
Product function
● web server		No
● shared device		No
● at the Ethernet interface Autonegotiation		No
● at the Ethernet interface Autosensing		No
● MRRT redundancy procedure		No
● is supported PROFINET system redundancy		No
● supports PROFIenergy measured values		No
● supports PROFIenergy shutdown		No
Type of electrical connection of the communication interface		D-sub / terminal
Installation/ mounting/ dimensions
Mounting position		any
Mounting type		screw and snap-on mounting
Height		111 mm
Width		45 mm
Depth		124 mm
Connections/Terminals
Product function
● removable terminal for auxiliary and control circuit		Yes
Type of electrical connection
● for auxiliary and control current circuit		screw-type terminals
Type of connectable conductor cross-sections
● solid		1x (0.5 ... 4.0 mm²), 2x (0.5 ... 2.5 mm²)
● finely stranded with core end processing		1x (0.5 ... 2.5 mm²), 2x (0.5 ... 1.5 mm²)
● at AWG conductors solid		1x (20 ... 12), 2x (20 ... 14)
● at AWG conductors stranded		1x (20 ... 14), 2x (20 ... 16)
Tightening torque
● with screw-type terminals		0.8 ... 1.2 N·m
Tightening torque [lbf·in]
● with screw-type terminals		7 ... 10.3 lbf·in
Ambient conditions
Ambient temperature
● during operation		-25 ... +60 °C
● during storage		-40 ... +80 °C
● during transport		-40 ... +80 °C
● at installation altitude ≤ 3000m during operation maximum		50 °C
● at installation altitude ≤ 4000 m during operation maximum		40 °C
Contact rating of auxiliary contacts according to UL		B300 / R300
Short-circuit protection
Design of short-circuit protection
● per output		Fuse links: gG 6 A, quick-response 10 A (IEC 60947-5-1), miniature circuit-breaker C char.: 1.6 A (IEC 60947-5-1) or 6 A (I_K < 500 A)
Safety related data
Protection against electrical shock		finger-safe
Galvanic isolation
Design of the electrical isolation		Protective separation in accordance with IEC 60947-1 for all circuits
Main circuit
Operating voltage
● at AC
— at 50 Hz rated value		110 ... 240 V
— at 60 Hz rated value		110 ... 240 V
Control circuit/ Control
Type of voltage of the control supply voltage		AC/DC
Control supply voltage at AC
● at 50 Hz rated value		110 ... 240 V
● at 60 Hz rated value		110 ... 240 V
Control supply voltage 1
● at DC rated value		240 V
Control supply voltage frequency 1 rated value		50 Hz
Control supply voltage frequency 2 rated value		60 Hz
Supply voltage
Type of voltage of the supply voltage		AC/DC
Certificates/approvals
General Product Approval EMC Declaration of Conformity sonstig sonstig
Further information
Information- and Downloadcenter (Catalogs, Brochures,…) http://www.siemens.com/industrial-controls/catalogs
Industry Mall (Online ordering system) https://mall.industry.siemens.com/mall/en/en/Catalog/product?mlfb=6AG1010-1AU00-4AA0
Cax online generator http://support.automation.siemens.com/WW/CAXorder/default.aspx?lang=en&mlfb=6AG1010-1AU00-4AA0
Service&Support (Manuals, Certificates, Characteristics, FAQs,...) https://support.industry.siemens.com/cs/ww/en/ps/6AG1010-1AU00-4AA0
Image database (product images, 2D dimension drawings, 3D models, device circuit diagrams, EPLAN macros, ...) http://www.automation.siemens.com/bilddb/cax_de.aspx?mlfb=6AG1010-1AU00-4AA0&lang=en
last modified:		01/30/2017