Technická data
Název:
SIPLUS S7-1500 16DQ 230VAC 1A ST TRIAC
Popis:
SIPLUS S7-1500 16DQ 230VAC 1A ST TRIAC -40 ... +70°C Startup -25°C with conformal coating BasedOn: 6ES7522-5FH00-0AB0 . SIMATIC S7-1500, DIGITAL OUTPUT MODULE DQ 16 X 230VAC / 1A,TRIAC; 16 CHANNELS IN GROUPS OF 2, 2A PER GROUP; SUBSTITUTE VALUE
Technické informace:
| General information | ||
| Product type designation | DQ 16x230VAC/1A ST (Triac) | |
| Firmware version | ||
| ● FW update possible | Yes | |
| Product function | ||
| ● I&M data | Yes; I&M0 to I&M3 | |
| Engineering with | ||
| ● PROFIBUS as of GSD version/GSD revision | V1.0 / V5.1 | |
| ● PROFINET as of GSD version/GSD revision | V2.3 / - | |
| Operating mode | ||
| ● DQ | Yes | |
| ● DQ with energy-saving function | No | |
| ● PWM | No | |
| ● Oversampling | No | |
| ● MSO | Yes | |
| Output voltage | ||
| Rated value (AC) | 120/230V AC, 50/60 Hz | |
| Power | ||
| Power available from the backplane bus | 1.2 W | |
| Power loss | ||
| Power loss, typ. | 11.1 W | |
| Digital outputs | ||
| Type of digital output | Triac | |
| Number of digital outputs | 16 | |
| Current-sinking | Yes | |
| Current-sourcing | Yes | |
| Short-circuit protection | No | |
| Switching capacity of the outputs | ||
| ● with resistive load, max. | 1 A | |
| ● on lamp load, max. | 50 W | |
| Output voltage | ||
| ● for signal "1", min. | L1 (-1.5 V) at maximum output current; L1 (-8.5 V) at minimum output current | |
| Output current | ||
| ● for signal "1" rated value | 1 A | |
| ● for signal "1" permissible range, min. | 10 mA | |
| ● for signal "1" permissible range, max. | 15 A; max. 1 AC cycle | |
| ● for signal "0" residual current, max. | 2 mA | |
| Output delay with resistive load | ||
| ● "0" to "1", max. | 1 AC cycle | |
| ● "1" to "0", max. | 1 AC cycle | |
| Parallel switching of two outputs | ||
| ● for logic links | No | |
| ● for uprating | No | |
| ● for redundant control of a load | Yes | |
| Switching frequency | ||
| ● with resistive load, max. | 10 Hz | |
| ● with inductive load, max. | 0.5 Hz | |
| ● on lamp load, max. | 1 Hz | |
| Total current of the outputs | ||
| ● Current per channel, max. | 1 A; see additional description in the manual | |
| ● Current per group, max. | 2 A; see additional description in the manual | |
| ● Current per module, max. | 10 A; see additional description in the manual | |
| Triac outputs | ||
| ● Size of motor starters according to NEMA, max. | 4 | |
| Cable length | ||
| ● shielded, max. | 1 000 m | |
| ● unshielded, max. | 600 m | |
| Isochronous mode | ||
| Isochronous operation (application synchronized up to terminal) | No | |
| Interrupts/diagnostics/status information | ||
| Diagnostics function | No | |
| Substitute values connectable | Yes | |
| Alarms | ||
| ● Diagnostic alarm | No | |
| Diagnostic messages | ||
| ● Monitoring the supply voltage | No | |
| ● Wire-break | No | |
| ● Short-circuit | No | |
| Diagnostics indication LED | ||
| ● RUN LED | Yes; Green LED | |
| ● ERROR LED | Yes; Red LED | |
| ● Monitoring of the supply voltage (PWR-LED) | No | |
| ● Channel status display | Yes; Green LED | |
| ● for channel diagnostics | No | |
| ● for module diagnostics | Yes; Red LED | |
| Potential separation | ||
| Potential separation channels | ||
| ● between the channels | No | |
| ● between the channels, in groups of | 2 | |
| ● between the channels and backplane bus | Yes | |
| Permissible potential difference | ||
| between different circuits | 250 V AC between the channels and the backplane bus; 500 V AC between the channels | |
| Isolation | ||
| Isolation tested with | 2500 V DC | |
| Ambient conditions | ||
| Ambient temperature during operation | ||
| ● horizontal installation, min. | -40 °C; = Tmin; Startup @ -25 °C | |
| ● horizontal installation, max. | 70 °C; = Tmax; see Derating BasedOn (e.g. manual), additionally Tmax > 60 °C max. 4 A aggregate current per module, max. 0.25 A per output | |
| ● vertical installation, min. | -40 °C; = Tmin; Startup @ -25 °C | |
| ● vertical installation, max. | 60 °C | |
| Relative humidity | ||
| ● With condensation, tested in accordance with IEC 60068-2-38, max. | 100 %; RH incl. condensation / frost (no commissioning in bedewed state), horizontal installation | |
| Decentralized operation | ||
| Prioritized startup | Yes | |
| Dimensions | ||
| Width | 35 mm | |
| Height | 147 mm | |
| Depth | 129 mm | |
| Weights | ||
| Weight, approx. | 310 g | |
| last modified: | 09/25/2017 |
|
